INTELI-POWER'S INTRODUCING THE ALL NEW! 80 Amp Electronic Power Converter WITH BUILT-IN CHARGE WIZARD
Note:Also included with all the PD9200 SERIES CONVERTERS is the PENDANT (SEE BELOW)!
Inteli-Power 9200 Converter Features:Reverse battery protection protects converters from damage resulting from improper (reverse) battery lead connection.
Two positive and negative connection terminals for easier wiring.
These solid-state converter/chargers deliver filtered DC power to all RV 12 Volt lighting and appliance circuits providing safe and reliable service.
Electronic current limiting automatically reduces output voltage when maximum capacity is reached. Protects your investment and offers peace of mind.
Low line voltage protection automatically shuts converters down if input voltage is insufficient and protects your appliances from damaging low voltage irregularities.
Intelligent cooling fan operates only under high load conditions giving you quieter nights.
High voltage protection protects converter from spikes or surge of voltage of over 135V.
Automatic thermal shutdown turns off converter when temperature exceeds 120ºF and protects converter from damage due to excessive heat.
Built-in Charge Wizard® that constantly monitors voltage status and automatically manages your RV battery.
The Converter Status Remote Pendant PD92201 is designed to plug into the standard accessory port on all models of the Inteli-Power 9200 Series Converters. The Converter Status Remote Pendant shows the charger/converter operating mode and allows for manual mode selection.
How it Works!
The new PD9200 Series RV Converter/Chargers have our patented Charge Wizard built-in to provide you with the most advanced RV battery charging system on the market today. The Charge Wizard is a micro-processor controller that constantly monitors your RV battery voltage and then automatically determines which one of four modes of operation is best suited to recharge or maintain optimum battery condition. The four modes are BOOST, NORMAL, STORAGE and DESULFATION. The Converter Status Remote Pendant will show you which mode the converter is operating in.
The Indicator Light on the Converter Status Remote Pendant will display the mode of operation as follows:
Light “ON” all of the time – Indicates the unit is in the BOOST MODE and the converter output voltage is 14.4-volts and is in the process of recharging the battery up to 90% of full charge as fast as possible. This mode is usually automatically selected after dry camping
Light Blinks Rapidly (every 2-3 seconds) – Indicates the unit is in the NORMAL MODE and the converter output voltage is 13.7-volts. In this mode, the converter is safely completing the charge of the RV battery.
Light Blinks Slowly (every 5-6 seconds) – Indicates the unit is in the Storage Mode and the converter output voltage has been lowered to 13.2-volts. In this mode the RV battery is fully charged and the converter is maintaining the charge, without causing gassing or water loss.
The Manual Switch...
The Manual Switch allows the operator to check to see if the Charge Wizard is operating properly as follows:
Press and hold the Manual Switch and shortly the Indicator Light will remain “ON” all of the time, indicating the unit went into the BOOST MODE. Continue to hold the switch and shortly the Indicator Light will start blinking rapidly (every 2-3 seconds). This indicates the unit went into the NORMAL MODE. Continue to hold the switch and the unit will go into the STORAGE MODE, and the Indicator Light will start blinking slowly (every 5-6 seconds). Once the switch button is released, the Charge Wizard will again read the RV battery voltage, and after some period of time, automatically select the proper mode of operation.
The Desulfation Mode
The DESULFATION MODE is only active when the Charge Wizard is in the STORAGE MODE. During this mode a timer in the micro-processor automatically switches the Charge Wizard to the BOOST MODE for 15-minutes every 21-hours. This higher voltage causes some slight gassing, and mixes up the battery electrolyte to prevent battery stratification, and the resulting sulfation of the plates, which is the leading cause of loss of battery power.
Note: When no 120 VAC power is applied to the RV through the Shore Power Cord, or Generator, the Indicator Light will remain "ON" at all times. This indicates that the Charge Wizard is monitoring the battery voltage.
Specifications:
Output: 13.6 VDC, 80 Amps
Input: 105-130 VAC, 50/60 Hz, 1300 Watts
Size: 3.6"H x 11.5" L x 9"W
Weight: 7.5 lbs
2-Year Standard Warranty!
